Sub-Station Structures are used to support power grid components and electrical equipments. Sub-Station Structures shall be fabricated from latticed angles, Pipes, Plates … etc. A common definition for sub-station structure is an assembly of equipments.
Switchyard Structure is generally applied for the assembly of switches, power circuit breakers, buses and auxiliary equipment, which are used to collect power from the generators of power plant and distribute to the transmission line at a load point. As far as structures are concerned the terms, Sub-Station and Switchyard structures will be used interchangeably
Transmission lines are power lines typically with voltage at 66KV and above. Voltage than 66KV are usually referred to as distribution lines. Transmission Line Sub-Station Structures are to be used for protection of Sub-Station equipments. Shield wires may also used for communications.
Electrical clearances provides physical separation needed for phase to phase, Phase to Structure and phase to grounds air gap to provide safe working areas and to prevent flashover.
Generally we use M.S./Alluminium Sheets, Structural Forms viz. Angles, Channels, Beam, Plates, Flats, Rounds…etc. Zinc, Primers & Paints. All these we purchases from the reputed manufacturers/traders with required Test Certificates.
Generally we supply our products with the finish of Hot Dip Galvanized, Primer coated, Enameled paint coated OR Epoxy paint coated.
A simple physical and laboratory tests to be conducted on the random selected samples with the following steps as per the requirements.
Our products being used by Power Plants, Cooling Towers Manufacturers, Railways, Refinery Projects, Fertilizer Industries, Cement Factories, Petrochemical Projects and Large Scale of Industrial Units.